JUNG KNX switch actuator, 24-gang, 16 A / 140 µF, rail mounting device, 12 rail units, Secure

Connecting this device to Matter

This product uses KNX. A compatible bridge can expose selected functions to Matter through its IP connection. The KNX device itself does not become a Matter over Thread device.

Selected native KNX functions can be mapped using a suitable Matter bridge. Additional probes, contacts, couplers, controlled equipment or temperature controllers may be required as described below. Exact device–bridge combinations have not been tested.

Commission the KNX installation in ETS, then configure the bridge with the required group addresses, data types and status feedback. Check the exact bridge firmware and your Matter platform. Native KNX functions, electrical ratings and Matter functions are separate specifications.

Function mapping is not a tested device–bridge pair or individual Matter certification for this KNX model. Protection functions and essential local automation should remain in the KNX installation.

Bridge options by function

These options match the product’s KNX functions to capabilities documented for a bridge. Open the bridge for its requirements and limitations.

Technical specifications

Switching

KNX connection

TP wired bus

Security

KNX Data Secure

KNX medium

TP 256

Commissioning mode

S-mode

Rated voltage KNX

DC 21 ... 32 V SELV

Current consumption

5 ... 24 mA

Ambient temperature

−5 ... +45 °C

Storage/transport temperature

−25 ... +70 °C

Connection mode

screw terminals

Mounting width

216 mm (12 rail units)

Total current of adjacent outputs

Σ 20 A

Total current of all outputs

Σ 240 A

Circuit breaker

max. B16

Switching voltage AC

AC 250 V ~

Mains frequency

50/60 Hz

Switching current AC1 (cos ϕ > 0.8)

16 A

Switch-on current

max. 235 A (1000 μs, 400 W HV LED)

Incandescent lamps

1500 W

Sources & limitations

Product research reviewed: Nov 5, 2026. This is separate from price, stock and installation-test dates.