Zennio
Eight-output multifunction actuator for switching loads, blinds or two-pipe fan-coil control.
This product uses KNX. A compatible bridge can expose selected functions to Matter through its IP connection. The KNX device itself does not become a Matter over Thread device.
Export only the ETS-selected output functions. Fan-coil mode requires additional temperature-control mapping. The bridge must handle the project’s KNX Secure setup. This SKU is distinct from the 277 V USA version. No specific device–bridge pair has been tested.
Commission the KNX installation in ETS, then configure the bridge with the required group addresses, data types and status feedback. Check the exact bridge firmware and your Matter platform. Native KNX functions, electrical ratings and Matter functions are separate specifications.
Function mapping is not a tested device–bridge pair or individual Matter certification for this KNX model. Protection functions and essential local automation should remain in the KNX installation.
These options match the product’s KNX functions to capabilities documented for a bridge. Open the bridge for its requirements and limitations.
Function mapping, not a tested device–bridge pair
Lighting control · Switched load / outlet · Shades / blinds
The bridge documents these function types. Commission the required KNX command and feedback objects in ETS, then map them in the bridge. Exact model pairing has not been tested; receiving-app support must also be checked.
View mapping source ↗Function mapping, not a tested device–bridge pair
Lighting control · Switched load / outlet · Shades / blinds
The bridge documents these function types. Commission the required KNX command and feedback objects in ETS, then map them in the bridge. Exact model pairing has not been tested; receiving-app support must also be checked.
View mapping source ↗Function mapping, not a tested device–bridge pair
Lighting control · Switched load / outlet · Shades / blinds
The bridge documents these function types. Commission the required KNX command and feedback objects in ETS, then map them in the bridge. Exact model pairing has not been tested; receiving-app support must also be checked.
View mapping source ↗Function mapping, not a tested device–bridge pair
Lighting control · Switched load / outlet · Shades / blinds
The bridge documents these function types. Commission the required KNX command and feedback objects in ETS, then map them in the bridge. Exact model pairing has not been tested; receiving-app support must also be checked.
View mapping source ↗Switching · Lighting · Shading · Fan coil
Product research reviewed: Nov 4, 2026. This is separate from price, stock and installation-test dates.